EB5AGV's FT-102 Technical Characteristics

Keep them glowing!

FT-102

Technical Characteristics

Frequency coverage

All amateur bands from 160 to 10 meters, WARC included

Operating modes

LSB,USB,CW,AM,FM (AM TX and FM TX/RX with optional module)

Power requirements

Receive: 95 VA (73 VA with heaters off)

Transmit: 440 VA (for 100W output)

Dimensions

368 x 129 x 309 (mm)

Weight

15 kg

TRANSMITTER

Carrier suppression

Better than -40dB at 14MHz

Sideband suppression

Better than -60dB (14MHz, 1 kHz tone)

Spurious radiation

Better than -40dB

Third order IMD

Better than -40dB (14MHz, 100W PEP)

Negative feedback level

Approx. -6dB at 14MHz

Frequency stability

Less than 300Hz drift during first 30 minutes after 10 minutes
warm-up.
Less than 100Hz every 30 minutes thereafter

Microphone input impedance

Low, 200 to 600 Ohm

RECEIVER

IF frequencies

8.2MHz and 455kHz

Image rejection

Better than 70dB from 1.8 to 21.5MHz
Better than 50dB from 24.5 to
29.9MHz

IF rejection

Better than 70dB

AF output

1.5W minimum (8 Ohm, 10% THD)

AF output impedance

4 to 16 Ohm

Selectivity (-6dB/-60dB)

SSB, CW, AM: 2.7/4.8kHz
Width adjust continuously from 2.7kHz to
500Hz

*Options

SSB nar, CW wide: 1.8/3.1 kHz (XF-8.2HSN filter)
CW nar: 600/1300
Hz (XF-8.2HC filter)
CW nar: 300/800 Hz (XF-8.2HCN filter)
CW nar:
500/1000 Hz (XF-455C filter)
CW nar: 270/600 Hz (XF-455CN
filter)
AM: 6/12.4 kHz (XF-8.2GA filter)

IF notch depth

Better than 40dB

Sensitivity (worst case in uV for 10dB (S+N)/N, except FM)

SSB (no optional filters) RF AMP ON: 0.25, RF AMP OFF: 1.0
CW (no
optional filters) RF AMP ON: 0.18, RF AMP OFF: 0.7
AM (no optional
filters) RF AMP ON: 1.0 , RF AMP OFF: 4.0
FM (for 20dB quieting) RF AMP
ON: 0.4 , RF AMP OFF: 3.0
CW (with APF ON) RF AMP ON: 0.05, RF
AMP OFF: 0.2
SSB (with XF-8.2HSN) RF AMP ON: 0.2 , RF AMP OFF:
0.8
CW (with XF-8.2HSN) RF AMP ON: 0.12, RF AMP OFF: 0.5

Dynamic range (with IF WIDTH control at maximum)

With no optional filters RF AMP ON: 90dB, RF AMP OFF: 95dB
With
XF-8.2HC filter RF AMP ON: 95dB, RF AMP OFF: 100dB
With XF-8.2HCN
filter RF AMP ON: 97dB, RF AMP OFF: 102dB

Please, let me know if you have any doubt,
comment or correction about the information shown in this page.

Go back to Main FT-102 Page